Product ID:SEAL COAST 350
MSDS Date:03/06/1989
FSC:6850
NIIN:00B020066
MSDS Number: BHCQC

BRULIN & COMPANY, INC.

SAN PABLO, CA 94806
US

Emergency Phone: 1-800-428-7149

Info Phone: 317-923-3211

Cage: DO828

BRULIN AND CO INC

270 INDIANAPOLIS, IN 46205-0270 US

Telephone: 317-923-3211

Cage: 94058

STODDARD SOLVENT

CAS: 8052-41-3

RTECS: WJ8925000

Fraction By Weight: 5-10%

OSHA PEL 500 PPM

ACGIH TLV: 100 PPM; 9293

DIPROPYLENE GLYCOL METHYL ETHER

CAS: 34590-94-8

RTECS: JM1575000

Fraction By Weight: 5-10%

OSHA PEL S,100PPM/150STEL

ACGIH TLV: S,100PPM/150STEL9192

METHYL CHLOROFORM (1,1,1-TRICHLOROETHANE) (SARA III)

CAS: 71-55-6

RTECS: KJ2975000

Fraction By Weight: 61%

OSHA PEL 350 PPM

ACGIH TLV: 350 PPM/450STEL;9394

EPA Report Quantity: 1000 LBS

DOT Report Quantity: 1000 LBS

AROMATIC PETROLEUM DISTILLATES

CAS: 64742-95-6

Fraction By Weight: 5-10%

Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Health Hazards Acute and Chronic:LIQUID AND VAPORS MAY CAUSE SLIGHT
TEMPORARY IRRITATION TO EYES. PROLONGED OR REPEATED SKIN CONTACT
MAY CAUSE IRRITATION. ORAL TOXICITY IS LOW;HOWEVER, IF ASPIRATED
INTO LUNGS,MAY BE RAPIDLY ABSORBED AND RESULT IN INJURY TO OTHER
BODY SYSTEMS. EXCESSIVE INHALATION MAY CAUSE CENTRAL NERVOUS SYSTEM
DEPRESSION,RESP IRRITA
Explanation of Carcinogenicity:DID NOT CAUSE CANCER IN LONG TERM ANIMAL
STUDIES. BIRTH DEFECTS ARE UNLIKELY. ANIMAL MUTAGENICITY RESULTS
HAVE BEEN NEG.
Effects of Overexposure:EYES-MAY CAUSE PAIN,REDNESS. SKIN-REPEATED
EXPOSURE MAY LEAD TO DRYING OR FLAKING SKIN. INHALATION-LEVELS OVER
1000 PPM MAY CAUSE DIZZINESS,DRUNKNESS. LEVELS OVER 10,000 PPM CAN
CAUSE UNCONSCIOUSNESS & DEATH.HIGH LEVELS MAY CAUSE
IRREGULARHEARTBEAT.INGESTION-MAY CAUSE NAUSEA,VOMITING,DIARRHEA.
Medical Cond Aggravated by Exposure:NONE KNOWN.

First Aid:INHALATION-REMOVE TO FRESH AIR. GIVE O2 IF BREATHING IS
DIFFICULT.EYES-FLUSH WITH LARGE AMOUNTS WATER FOR 15 MIN, LIFTING
LIDS.INGESTION-DO NOT INDUCE VOMITING. DILUTE WITH WATER. GIVE MILK
OF MAGNESI A.KEEP WARM,QUIET. GET MEDICAL ATTENTION FOR ALL THE
PROCEDING EXPOSURES.SKIN-WASH WITH MILD SOAP & WATER. REMOVE &
LAUNDER CONTAMINATED CLOTHING. FOR PHYSICIAN INSTRUCTIONS SEE
"OTHER PRECAUTIONS".

Flash Point Method:PMCC
Flash Point:>140F
Extinguishing Media:FOAM,DRY POWDER,CARBON DIOXIDE.
Fire Fighting Procedures:SELF-CONTAINED POSITIVE PRESSURE RESPIRATORY
EQUIPMENT SHOULD BE USED BY FIRE FIGHTERS.
Unusual Fire/Explosion Hazard:NEVER USE WELDING OR CUTTING TORCH ON OR
NEAR DRUM, EVEN EMPTY.

Spill Release Procedures:SMALL SPILLS-MOP,WIPE OR SOAK UP IMMEDIATELY.
REMOVE TO OUTDOORS. LARGE SPILLS-EVACUATE AREA AND VENTILATE WELL.
CONTAIN LIQUID AND TRANSFER TO METAL CONTAINERS. REPORTABLE
QUANTITY (RQ) OF METHYL CHL OROFORM IS 1000 LBS.

Handling and Storage Precautions:STORE IN A COOL,DRY PLACE. ALUMINUM IS
NOT AN ACCEPTABLE MATERIAL OF CONSTRUCTION FOR PUMPS,MIXERS,OR
STORAGE TANKS FOR METHYL CHLOROFORM.
Other Precautions:NOTE TO PHYSICIAN-THIS PRODUCT CAN INDUCE CARDIAC
SENSITIZATION TO CIRCULATING EPINEPHRINE-LIKE COMPOUNDS. DO NOT
GIVE ADRENALINE OR SIMILAR SYMPATHOMIMETIC DRUGS. DON'T ALLOW
VICTIM TO EXERCISE FOR 2 4 HOURS FOLLOWING EXPOSURES.

Respiratory Protection:IF TLV IS EXCEEDED,USE SELF CONTAINED RESPIRATOR
APPROVED BY NIOSH/MSHA. CONSULT SAFETY EQUIPMENT SUPPLIER.
Ventilation:PROVIDE SUFFICIENT MECHANICAL(GENERAL AND/OR LOCAL EXHAUST)
VENTILATION TO MAINTAIN EXPOSURE BELOW TLV (S).
Protective Gloves:WEAR RESISTANT GLOVES IS SKIN CONTACT.
Eye Protection:GOGGLES/SAFETY GLASSES.
Other Protective Equipment:AS NECESSARY TO PREVENT SKIN CONTACT.
Work Hygienic Practices:AVOID BREATHING VAPORS OR MISTS. CONCENTRATED
VAPORS ARE HEAVIER THAN AIR AND MAY COLLECT IN PITS,STORAGE
TANKS,ETC.
Supplemental Safety and Health
DO NOT ENTER LOW AREAS SUCH AS PITS,STORAGE TANKS,CONFINED AREAS WHERE
VAPORS MAY CONCENTRATE,WITH WEARING SPECIAL BREATHING APPARATUS.

Boiling Pt:B.P. Text:165F
Melt/Freeze Pt:M.P/F.P Text:<0F
Vapor Pres:100 MTHCHL
Vapor Density:>4
Spec Gravity:1.102
Evaporation Rate & Reference:APPROX 6.0
Solubility in Water:NEGLIGIBLE
Appearance and Odor:CLEAR LIQUID,MILD CHLORINATED ODOR.

Stability Indicator/Materials to Avoid:YES
WATER-LONG TERM CONTACT CAN DEPLETE STABILIZERS FOLLOWED BY SLOW
HYDROLYSIS PRODUCING CORROSIVE ACID.
Stability Condition to Avoid:OPEN FLAMES,WELDING ARCS OR OTHER HIGH
TEMPERATURE SOURCES WHICH INDUCE THERMAL DECOMPOSITION.
Hazardous Decomposition Products:CARBON MONOXIDE,CARBON
DIOXIDE,HYDROGEN CHLORIDE AND VERY SMALL AMOUNTS OF PHOSGENE AND
CHLORINE.

Waste Disposal Methods:DISPOSE ACCORDING TO FEDERAL,STATE AND LOCAL
LAWS AND 40 CFR.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.